User Manual Q&AAnswer
Feb 07, 2025 - 03:17 AM
To replace the antenna on the n-com SPCOM00000026, please follow these steps:
1. Remove the N-Com system from the helmet as instructed in the provided instruction booklet.
2. Open the e-box by unscrewing the xxxx and removing the connector cover (refer to Fig. 1-3 in the manual).
3. Disconnect the antenna connector (refer to Fig. 4-5).
4. Place the new antenna inside the plastic box (e-box) (refer to Fig. 6).
5. Connect the new antenna to the antenna connector.
6. xxxx the connector cover back in place.
7. Close the e-box (refer to Fig. 7).
8. Reposition the N-Com system inside the helmet following the instructions in the provided instruction booklet.
Please note that it is essential to refer to the instruction manual specific to your n-com SPCOM00000026 model for accurate guidance and illustrations.
Add New Comment