User Manual Q&AAnswer
Feb 07, 2025 - 02:31 AM
Sure! Here are the step-by-step instructions for replacing the n-com SPCOM00000072 Connector Cover:
1. Remove the N-Com system from the helmet: Start by taking out the N-Com system from your helmet. Refer to Figures 1-3 in the instruction manual for visual guidance.
2. Remove the screws: Use a Torx T6 screwdriver to remove the screws that hold the plastic cover in place. Figure 4 in the manual illustrates this step.
3. Move the plastic cover: Once the screws are removed, carefully move the plastic cover from its housing. Be gentle to avoid any damage.
4. Position the new connector cover cap: Take the new connector cover cap and position it in the housing. Make sure it fits securely. Refer to Figure 5 for assistance.
5. Reposition the protection cover: Align the protection cover with the two holes where the screws pass through. Carefully place it back in its original position. Figure 6 in the manual can help you with this step.
6. Replace and tighten the screws: Insert the screws back into their respective holes and tighten them using the Torx T6 screwdriver. Ensure they are securely fastened.
7. Reposition the N-Com system inside the helmet: Finally, reposition the N-Com system back inside your helmet following the instructions provided in the accompanying instruction booklet.
By following these instructions, you should be able to successfully replace the n-com SPCOM00000072 Connector Cover. If you encounter any difficulties or have further questions, please consult the instruction manual for additional guidance.
Add New Comment