User Manual Q&AAnswer
Feb 07, 2025 - 01:45 AM
To replace the N-Com system in your helmet, please follow these steps:
1. Remove the N-Com system from the helmet by referring to the instruction booklet provided with the product.
2. Open the e-box (electronic box) of the N-Com system. You can refer to Figure 1-2 in the instruction manual for visual guidance.
3. Disconnect the antenna connector from the e-box. This can be done by gently pulling the connector away from the e-box. Refer to Figure 3 in the manual for reference.
4. Place the new antenna inside the plastic box (e-box) of the N-Com system.
5. Connect the new antenna to the e-box. Ensure that the connector is securely attached.
6. If you are using the BX4 model, position the cable in the special fixing hook as shown in Figure 4 of the manual.
7. Close the e-box by securely fastening it. Refer to Figure 5 for proper closure.
8. Make sure that all fixing points are properly secured to ensure stability and safety.
9. Reposition the N-Com system inside the helmet according to the instructions provided in the instruction booklet.
By following these steps, you should be able to successfully replace the N-Com system in your helmet.
Add New Comment