User Manual Q&AAnswer
Feb 07, 2025 - 01:44 AM
To replace the left wiring connector on the n-com SPCOM00000039 computer board, please follow the instructions below:
1. Remove the N-Com system from the helmet by referring to the instruction booklet provided.
2. Open the e-box, which is the plastic enclosure where the computer board is located (refer to Fig. 1-2 in the instruction manual).
3. Carefully remove the left wiring that needs to be replaced. Lift up the cable feedthrough (Fig. 3) and then take out the connector from its housing (Fig. 4).
4. Position the new left wiring connector in the counterpart on the electronic card (Fig. 5). Ensure it is securely inserted.
5. Secure the cable feedthrough in the special seat on the edge of the plastic e-box (Fig. 6).
6. Close the e-box, ensuring it is properly sealed (Fig. 7).
7. Double-check that all fixing points are securely fastened.
8. Reposition the N-Com system back inside the helmet according to the instructions provided in the booklet.
Please note that these instructions are a general guide, and it is always recommended to refer to the specific instruction manual for your n-com SPCOM00000039 computer board for accurate and detailed steps.
Add New Comment