User Manual Q&AAnswer
Feb 07, 2025 - 01:41 AM
To replace the left cable (SPCOM00000028) on your N-Com system, please follow these instructions:
1. Remove the N-Com system from your helmet by referring to the instruction booklet provided with the product.
2. Open the e-box, which is the electronic control unit of the N-Com system (refer to Fig. 1-2 in the instruction manual).
3. If necessary, disconnect the antenna connector from the e-box (refer to Fig. 3-4). This step may not be required if your antenna was not previously removed.
4. Locate the wiring that needs to be replaced and carefully remove it from the electronic card. Take note of its position and connections.
5. Position the new wiring connector in the counterpart on the electronic card, ensuring it is properly aligned and connected (refer to Fig. 5).
6. If you had previously disconnected the antenna, reconnect it to the electronic card at this stage.
7. Close the e-box securely, making sure it is properly sealed (refer to Fig. 6-7).
8. Reposition the N-Com system back inside your helmet, following the instructions provided in the accompanying instruction booklet.
Please note that these instructions are a general guide and it is always recommended to consult the specific instruction manual for your N-Com system model (SPCOM00000028) for detailed and accurate information.
Add New Comment