User Manual Q&AAnswer
Feb 06, 2025 - 10:27 PM
To install the Garnet Instruments 709-4P SeeLeveL II Tank Monitor and wire the 3-way switch, please follow the steps outlined below:
1. Before starting the installation, make sure to disconnect all power sources to avoid any electrical hazards.
2. Locate a suitable location for the monitor display unit. It should be easily accessible and visible for monitoring the tank levels.
3. Mount the display unit using the provided mounting bracket or screws, ensuring it is securely attached.
4. Connect the wiring harness to the back of the display unit. The wiring harness consists of multiple wires, each with a specific function.
5. Identify the wires labeled "Power" and "Ground" on the wiring harness. Connect the "Power" wire to a 12-volt power source, such as the positive terminal of the battery or a fused power source.
6. Connect the "Ground" wire to a suitable ground point, such as the negative terminal of the battery or a metal chassis.
7. Locate the 3-way switch that is included with the monitor. This switch allows you to toggle between monitoring multiple tanks.
8. Identify the wires labeled "Switch" on the wiring harness. Connect these wires to the appropriate terminals on the 3-way switch. The specific wiring configuration will depend on the number of tanks you are monitoring and the desired tank selection.
9. Once the wiring is complete, double-check all connections to ensure they are secure and properly insulated.
10. Reconnect the power source and turn on the monitor display unit. You should now be able to see the tank levels on the display.
Please note that the above instructions are a general guide, and it is important to refer to the specific installation guide provided by Garnet Instruments for detailed instructions and any additional considerations specific to your installation.
Add New Comment