User Manual Q&AAnswer
Feb 06, 2025 - 09:36 PM
The ELSEMA PCK43304W transmitter can be programmed with the Penta series receivers using either the 12-way dip switch coding or encrypted coding methods.
For 12-way dip switch coding:
1. Set a random code on the receiver's dip switch by flicking the dip switches "On" or "Off". Do not use the default factory setting for the 12-way dip switch as this is a common code.
2. Open the cover of the PentaCODE transmitter.
3. Match the 12-way dip switch on the transmitter to the receiver's 12-way dip switch.
4. Activate channel 1 on the transmitter, and the receiver output should activate, indicated by the receiver LED.
To program channels 2, 3, or 4 of the same transmitter to another receiver, change dip switch 11 and 12 in the 2nd, 3rd, and 4th receivers according to the table provided in the manual.
For encrypted coding (all 12-way dip switches must be "Off"):
Coding the PentaCODE transmitter and receivers can be done in three different ways: receiver to a transmitter, transmitter to a receiver, or transmitter to another transmitter.
To program receiver to a transmitter:
1. Press and hold the program button 1 on the receiver.
2. Activate channel 1 of the transmitter for 2 seconds, and the receiver LED will flash green.
3. Deactivate channel 1 of the transmitter, then release the receiver program button.
4. The LED on the PentaCODE transmitter will flash to confirm successful coding.
To program transmitter to a receiver or transmitter to another transmitter:
Set one of the transmitter or receiver to broadcast its code. The broadcaster's code will be programmed to the other units.
1. To broadcast the transmitter's code, make sure all 12 dip switches are "Off". Then activate channel 1 and flick dip switch 12 "On" and then "Off". This is confirmed by the LED being "On" for 10 seconds. You can release channel 1.
2. To broadcast the receiver's code, make sure all 12 dip switches are "Off" and then flick dip switch 12 "On" and then "Off". This is confirmed by the green LED being on for 10 seconds.
3. While broadcasting the code, activate channel 1 on a different transmitter or receiver for 1 second and then release the input. The LED will flash twice to confirm successful programming.
4. Broadcasting will be latched on for 10 seconds or stop if any dip switch is turned on.
To delete receivers' memory:
Short the CC pin on the receiver for 10 seconds. This will delete all the transmitters from the receiver's memory.
Add New Comment