User Manual Q&AAnswer
Feb 06, 2025 - 08:11 PM
To install the SPOT LIGHT KAGO Pendant Oak Wood Table Lamp, please follow these instructions:
1. Ensure that the power supply cable is not energized. Before starting the installation work, switch off the mains cable, fuse-box, or remove the fuses. Make sure the ON/OFF switch is set to "OFF" or "0". Check the absence of voltage with a voltage tester.
2. The light fitting should be installed by a licensed electrician in compliance with valid regulations for electrical installation. The manufacturer is not liable for injuries or damages resulting from improper use of the light fitting.
3. The light is suitable for mounting on normally flammable surfaces. Ensure that the casings have been correctly installed.
4. Do not mount the light on damp or electrically conductive ground.
5. The temperature of the elements of the light fitting and light-emitting elements may exceed 180°C during operation. Do not touch the light fittings and light sources during and after operation and allow them to cool.
6. Before replacing light sources (bulbs), ensure that they are cooled down. Turn off the power supply and fuses if necessary before connecting the light.
7. Defective light sources may only be replaced in accordance with the marking on the light fitting (see labels).
8. The power of light bulbs used should not be greater than specified on the rating label.
9. Adjust and change settings of the light fitting only after it has cooled down.
10. Clean only the fitting housing. Do not allow water or moisture to enter contacts or parts that supply current.
11. If there is a defective external moving cable, it can only be replaced by the manufacturer, its service technician, or a qualified person to avoid hazards.
Please refer to the instruction manual for further details and safety precautions.
Add New Comment