User Manual Q&AAnswer
Feb 06, 2025 - 04:40 AM
To install the FLASHFORGE F Extruder for Creator 4 3D Printer and the filament support, follow these steps:
1. Fix the metal support above the mounting hole on the right side of the equipment using screws. This metal support will hold the filament support in place.
2. Install the material barrel on the metal material rack and xxxx it tightly. The material barrel is where the filament will be loaded into.
3. Put the filament spool on the filament support. The filament support is designed to hold the filament spool securely.
Once the installation is complete, you can load the filament directly from above the extruder when printing flexible filaments. It is important to note that when printing non-flexible filaments, you have the flexibility to choose the placement location of the filaments according to your preference. When not printing, you can bend the filament support 90 degrees and close the upper cover of the equipment.
For further information or visual reference, you can refer to the instruction manual provided by FLASHFORGE or visit their official websites at www.sz3dp.com and www.flashforge.com.
Add New Comment