User Manual Q&AAnswer
Feb 06, 2025 - 04:10 AM
To install the ABH PT105SC Square Corner Power Transfer with swing clear hinges at a 90-degree angle, please follow the instructions provided in the installation template. Here are the important notes and considerations for installation:
1. Use the transfer case housing as a drilling template for accurate installation.
2. Only stranded wires should be employed for the power transfer.
3. The spring conduit is designed to fit wire bundles up to 5/16" thick.
4. Take caution when inserting wires through the power transfer device.
5. Ensure that the rectangular cut-out for the power transfer is at least 11/16" deep for wood frames and doors.
6. It is recommended to label the wires for easy identification.
7. The size and number of wires used must comply with the National Electrical Code (NEC), NFPA, and local electrical codes.
8. This power transfer device is intended for low voltage use only, with a maximum of 30 VAC, 42.5 VDC, and 10 watts.
By following these instructions and considering the important notes, you can successfully install the ABH PT105SC Square Corner Power Transfer with swing clear hinges at a 90-degree angle.
Add New Comment