User Manual Q&AAnswer
Feb 06, 2025 - 03:57 AM
To install and connect the Gallardo SEVCL-50 Electric Exhaust Valve SET with Wireless Remote Control, please follow these steps:
1. Locate the electronic accelerator in the back of the gas pedal, which is usually found behind the driver's door.
2. Connect the yellow/white cable from the electronic valve to the TPS voltage signal (0~5V) of the electronic accelerator.
3. Connect the purple cable from the electronic valve to the key on switch (red cable) and hang it on the ground (GND).
4. Connect the yellow cable from the remote control system to the TPS voltage signal (0~5V).
5. Connect the brown cable from the remote control system to the ground (GND).
6. Connect the red cable from the remote control system to the key on switch.
By following these steps, you should be able to install and connect the Gallardo SEVCL-50 Electric Exhaust Valve SET with Wireless Remote Control successfully. For further assistance, please refer to the provided instruction manual.
Add New Comment