How do I install the CPU and memory modules in the Shuttle DH670 with 12th Generation? (Shuttle DH670 Drives Four Displays 12th Generation User Guide)

Answer

manuals.plus

Feb 06, 2025 - 02:10 AM


To install the CPU in the Shuttle DH670 with 12th Generation, follow these steps:

1. Ensure that the computer is turned off and the power cord is unplugged.
2. Unscrew the four ICE module attachment screws and unplug the fan connector. Remove the ICE module from the chassis.
3. Unlock and raise the socket lever.
4. Lift the metal load plate of the CPU socket. Make sure not to touch the socket contacts.
5. Orientate the CPU correctly and align the CPU notches with the socket alignment keys. Gently push the CPU into the socket.
6. Tear off the protective membrane from the metal load plate. Close the metal load plate, lower the CPU socket lever, and lock it in place.
7. Spread the thermal paste evenly on the CPU surface.
8.  xxxx  the ICE module back onto the motherboard, pressing down on the opposite diagonal corner while tightening each  xxxx .
9. Connect the fan to the appropriate connector.

To install memory modules in the Shuttle DH670 with 12th Generation, follow these steps:

1. Locate the SO-DIMM slots on the motherboard.
2. Align the notch of the memory module with one of the relevant memory slots.
3. Gently insert the module into the slot at a 45-degree angle.
4. Carefully push down the memory module until it snaps into the locking mechanism.
5. Repeat the above steps to install an additional memory module if required.

Please refer to the product manual for more detailed instructions and illustrations.