User Manual Q&AAnswer
Feb 06, 2025 - 12:20 AM
To install the PPK Kit on your DJI Phantom 4 Pro or Advance Drone, please follow the steps below:
1. Glue one side of the velcro to the center back of the Emlid Reach M2 or M+ module.
2. Connect the 6-pin connector of the module bracket to the S1 connector of the module.
3. Connect the 5-pin connector of the Photo Trigger Sensor to the C1 connector of the module.
4. Use the velcro to firmly place the module on the Module Holder.
5. Install the module bracket on the bottom of the left landing gear of the Drone, using the two lugs on the crossbar. Insert one lug first and then slide the crossbar upwards until the other lug can be easily inserted.
6. Plug the Micro-USB cable into the USB slot of the Drone.
7. Remove the clear plastic Clip located at the end of the left front arm of the Drone.
8. Carefully insert the Trigger Sensor under the motor of the Drone's left front arm.
9. Install the GNSS antenna on the Antenna Bracket using the short connector cable provided. Before screwing the connector to the antenna, unscrew the supplied fixing nut and save it.
10. Firmly attach the Antenna Mount to the top of the Drone using the Velcro provided. Make sure the installation position of the antenna mount is just above the location of the Drone camera. Ensure that the propellers of the Drone, when turning, do not touch the support, leaving a safety margin of five millimeters.
11. Connect the antenna cable to the module. Be careful not to block the view of the Drone's anti-collision system. If using the long connection cable provided by Emlid, wrap the antenna cable around the bracket and secure it in place with a tie wrap.
Please refer to the user manual for more detailed instructions and illustrations on the installation process.
Add New Comment