User Manual Q&AAnswer
Feb 05, 2025 - 11:47 PM
To install the Vogel's PFW 6706 Video Wall Pop-Out Module, please follow the steps below:
1. Start by determining the desired location for your video wall. Ensure that the wall is strong enough to support the weight of the displays.
2. Use a stud finder to locate the studs in the wall. Mark the positions of the studs to ensure proper installation.
3. Attach the wall plate of the PFW 6706 to the wall using suitable screws and wall plugs. Make sure to align the wall plate with the marked stud positions for maximum stability.
4. Connect the display brackets to the back of each display. The PFW 6706 is compatible with displays weighing up to 45 kg / 99 lbs and with a mounting pattern of 200 x 200 to 600 x 800 mm.
5. Hang the displays onto the wall plate by aligning the display brackets with the corresponding slots on the wall plate. Ensure that the displays are securely attached.
6. Adjust the position of each display by using the push-in, pop-out functionality of the PFW 6706. This allows you to easily align the displays and create the desired video wall configuration.
7. Use the included cable clip for cable management. This will help keep your cables organized and hidden from view.
8. Finally, double-check the stability of the video wall and make any necessary adjustments to ensure that all displays are level and aligned properly.
For more detailed instructions and illustrations, please refer to the Vogel's PFW 6706 Video Wall Pop-Out Module User Manual.
Add New Comment