User Manual Q&AAnswer
Feb 05, 2025 - 11:10 PM
To set up the gofanco HDExtIPv2 HDMI IP Extender for one-to-one configuration, please follow these steps:
1. Power off all devices, including your HDMI source and HDMI display.
2. Connect your HDMI source device to the Transmitter's HDMI Input connector using an HDMI cable (not included).
3. Optional: Connect an HDMI display to the Transmitter's HDMI out connector using an HDMI cable (not included) for local monitoring of the HDMI signal.
4. Optional: Connect the IR Blaster Extension Cable to the Transmitter's IR output port. Face the eye towards your HDMI source device's IR window. This connection is only needed if you need to control your HDMI source from the remote location.
5. Plug your CAT5e/6 cable between the Transmitter's RJ45 Output and the Receiver's RJ45 Input.
6. Connect your HDMI display to the Receiver's HDMI output connector using an HDMI cable (not included).
7. Optional: Connect the IR Receiver Extension Cable to the Receiver's IR input port. This connection is only needed if you need to control your HDMI source device from the remote location.
8. Plug the included power adapters into the Transmitter's and Receiver's power jacks, then plug both power adapters into a reliable power source.
9. Power on all connected devices.
10. The HDMI extender is now ready for use.
Please refer to the gofanco HDExtIPv2 HDMI IP Extender User Guide for more detailed information and troubleshooting tips.
Add New Comment