User Manual Q&AAnswer
Feb 05, 2025 - 10:58 PM
To connect the Rayrun N10 Single Color LED Wireless Remote Controller to your LED fixtures, follow these steps:
1. Connect the positive power cable from your power supply to the terminal marked with a '+' on the controller.
2. Connect the negative power cable from your power supply to the terminal marked with a '-' on the controller.
3. Connect the positive LED load cable from your LED fixtures to the terminal marked with a '+' on the controller.
4. Connect the negative LED load cable from your LED fixtures to the terminal marked with a '-' on the controller.
Please ensure that the LED rated voltage is the same as the power supply voltage. Also, make sure that the maximum load current of your LED fixtures is lower than the controller's rated current to avoid overloading or short circuiting the controller.
Add New Comment