User Manual Q&AAnswer
Feb 05, 2025 - 10:49 PM
To connect the Rayrun T122 2 Wire CCT LED Advanced RF Remote Controller to your LED lights, follow these steps:
1. Power supply input: Connect the power supply to the controller's power input. Make sure to check the polarity indicated on the controller and connect the positive power cable to the output PLUS cable inside the controller. The controller's power supply voltage range is DC 5V to 24V.
2. LED output: Connect your LED loads to the controller's LED output. Refer to the print on the controller for cable polarity and connect the LED load with the corresponding polarity. Ensure that the LED's rated voltage matches the power supply voltage, and the maximum load current is below the controller's rated current.
3. Wiring diagram: It is important to ensure that the output cables do not short circuit, as this could permanently damage the controller. Make sure all cables are well insulated and connected properly before powering on.
Please refer to the user manual for more detailed instructions and illustrations on the wiring process.
Add New Comment