User Manual Q&AAnswer
Feb 05, 2025 - 10:44 PM
To connect the Rayrun N12 LED dimmer to your LED fixtures, follow these steps:
1. Power supply input: Install the positive power cable into the terminal marked with ‘+’ and the negative power cable into the terminal marked with ‘-’. The controller can accept DC power from 5V to 24V. Make sure the LED rated voltage is the same as the power supply.
2. LED output: Connect your LED fixtures to the terminal. Install the positive LED load cable into the terminal marked with ‘+’ and the negative cable into the terminal marked with ‘-’. Ensure that the LED rated voltage is the same as the power supply and the maximum load current is lower than the controller’s rated current.
Remember, do not power on the controller until all connections are firmly finished. Also, use the remote controller to turn on the unit if it was switched to off status before a previous power cut.
For further troubleshooting or if the controller runs into protection, refer to the indicator lights and check the wiring and load current to resolve the issue.
Add New Comment