User Manual Q&AAnswer
Feb 05, 2025 - 10:05 PM
To connect the Rayrun N40 RGB+W LED Controller to your LED fixtures, follow these steps:
1. Power supply input: Install the positive power cable into the terminal marked with ‘+’ and the negative power cable into the terminal marked with ‘-’. The controller accepts DC power from 5V to 24V, so make sure the LED rated voltage is the same as the power supply.
2. LED output: Connect your LED fixtures to the controller. Install the LED common anode cable into the terminal marked with ‘+’, and each channel LED cable into the terminals marked with R, G, B, and W. Ensure that the LED rated voltage is the same as the power supply, and each channel's maximum load current is below the controller's rated current.
Note: The controller will go into protection mode if the output is overloaded or short-circuited. In this case, the indicator will flash red, and the controller will stop working. Check the wiring and load current to resolve the issue.
For more detailed information and illustrations, please refer to the Rayrun N40 RGB+W LED Controller User Manual.
Add New Comment