User Manual Q&AAnswer
Feb 05, 2025 - 09:53 PM
To connect LED fixtures to the Rayrun N30 RGB LED Controller, you will need to follow these steps:
1. Locate the LED output terminal on the controller. This terminal is marked with a symbol.
2. Install the LED common anode cable into the terminal marked with the symbol. This cable is responsible for the common positive connection of the LED fixtures.
3. Connect each channel LED cable into the terminals marked with R, G, B. These terminals correspond to the red, green, and blue channels of the LED fixtures.
4. Make sure that the LED fixtures' rated voltage is the same as the power supply connected to the controller. Additionally, ensure that the maximum load current of each channel is below the controller's rated current. Overloading or short circuiting the output can trigger the controller's protection mechanism.
5. If the controller detects an overload or short circuit, the indicator will flash red and stop working. In such cases, check the wiring and load current to resolve the issue.
Please refer to the user manual for further information and illustrations on the wiring process.
Add New Comment