User Manual Q&AAnswer
Feb 05, 2025 - 09:52 PM
To set the time on your Lumoday CA-14WD Sleep and Charge clock, follow these steps:
1. Press and hold the "Set" button until the hour digit starts to flash.
2. Release the button.
3. Use the "HR" and "MIN" buttons to adjust the time. As you cycle through 1-12, the hours will change from AM to PM.
4. Press the "Set" button to exit the setup. If no button is pressed for about 10 seconds, it will automatically exit the setup.
For more detailed instructions, please refer to the Lumoday CA-14WD Sleep and Charge User Guide.
Add New Comment