User Manual Q&AAnswer
Feb 05, 2025 - 09:16 PM
To mount the EUROM 800, 1200 Alutherm Sani WiFi on the wall, follow these steps:
1. Choose a wall made from non-flammable material that can withstand a minimum temperature of 200 °C.
2. Ensure that you have a suitable fastening material depending on the surface.
3. Place the device on a vertical and solid surface, using a spirit level to ensure it is level.
4. Leave the following minimum distances between the device and surrounding objects:
- 150 cm from the ceiling
- 30 cm from the side walls
- 30 cm from the floor
- 50 cm clearance on the front side
5. Do not mount the device immediately below a socket outlet or on a ceiling or roof.
6. Drill two holes with approximately 160 mm between them, at the specified height for your model (773 mm for Alutherm Sani 800, 918 mm for Alutherm Sani 1200).
7. Insert wall plugs into the holes.
8. xxxx two large screws into the wall, leaving them protruding a few millimeters.
9. Lay the device down on a soft steady surface.
10. xxxx and tighten three brackets on both sides of the main body using a small xxxx and a Phillips screwdriver. The lowest bracket acts as a spacer to maintain the distance between the heater and the wall.
11. Place the bracket holes over the wall screws.
12. Slide the device to the left and let it drop into the brackets.
13. Ensure that the device is securely mounted on the wall screws.
Please refer to the user manual for detailed illustrations and additional safety precautions during the mounting process.
Add New Comment