User Manual Q&AAnswer
Feb 05, 2025 - 04:45 AM
To install the Evenflo 38111190 Tribute 5 Convertible Car Seat in your vehicle, please follow these steps:
1. Start by determining whether you will be using the car seat in rear-facing or forward-facing mode, based on your child's age, weight, and height. Refer to the car seat's manual for the specific requirements.
2. Position the car seat in the desired seating location in your vehicle. It is recommended to install the car seat in the rear seat of the vehicle.
3. If installing in rear-facing mode, make sure the car seat is reclined at the appropriate angle. Adjust the recline angle by using the recline foot located at the front of the car seat. Refer to the manual for the correct recline angle based on your child's age and weight.
4. Route the vehicle's seat belt or LATCH belt through the appropriate belt path on the car seat. The belt path will differ depending on whether you are installing the car seat in rear-facing or forward-facing mode. Refer to the manual for the correct belt path.
5. Buckle the vehicle's seat belt or attach the LATCH connectors to the vehicle's anchor points, ensuring a secure connection.
6. Tighten the seat belt or LATCH belt to remove any slack. Follow the instructions in the manual to properly secure the car seat.
7. Perform a thorough check to ensure the car seat is securely installed. Push and pull the car seat from different angles to check for any excessive movement. The car seat should be snug and not move more than an inch in any direction.
8. Double-check that the car seat's harness is properly adjusted and securely fastened around your child.
For more detailed instructions and illustrations, please refer to the Evenflo 38111190 Tribute 5 Convertible Car Seat Owner's Manual, which provides step-by-step installation guidance specific to your car seat model.
Add New Comment