How do I install the Harvest Tec 347U 25 Gallon Automatic Preservative Applicator? (HARVEST TEC 347U Gallon Automatic Preservative Applicator Instruction Manual)

Answer

manuals.plus

Feb 04, 2025 - 06:36 AM

To install the Harvest Tec 347U 25 Gallon Automatic Preservative Applicator, follow the steps outlined in the instruction manual. Here is a summary of the installation process:

1. Installation of Tank, Mounting Brackets, and Drain/Fill Line:
- Mount the tank base bracket on the front of the baler using the provided hardware.
- Secure the tank to the tank base bracket using the supplied bolts, washers, and nuts.
- Connect the drain/fill line to the tank and run it down the frame of the baler.
- Secure the valve assembly to the other end of the hose.

2. Mounting Control Box:
- Position the control box on the tank saddle and secure it using the supplied screws, washers, and nuts.

3. Placement of Nozzle Holders:
- Mount the nozzle holders on the wind guard above the pick-up head using the supplied U bolts.
- Position the nozzle holders 6 inches apart on a 4-foot span, ensuring that the tips spray in a horizontal direction over the top of the baler's pickup.

4. Installation of Plumbing:
- Route the intake hose from the bottom of the tank to the ball valve attached to the pump plate.
- Connect the discharge hose from the pump output to the solenoid assembly.
- Connect the 1/4" hose to the outgoing side of the solenoid to the tip assembly.

5. Installation of Moisture Sensor Pads:
- If your baler is equipped with bale shaping pads, remove the disc and use the existing hole to install the moisture sensing discs.
- If your baler is not equipped with bale shaping pads, drill a hole in the chamber directly behind and above the starting roll.
- Install the plastic pad and moisture sensing disc according to the provided template and instructions.

6. Installation of Bale Sensor:
- Mount the bale rate timer sensor bracket on the right side of the baler, 1-6 inches down from the hinge.
- Install the sensor into the bracket, leaving a 1/4" clearance between the end of the sensor and the door.
- Route the harness towards the DCP and secure it with cable ties.

7. Installation of iPad Integration Control:
- Locate a safe location in the cab of the tractor to place the iPad Integration Control.
- Connect the Power/Communication harness to the bottom of the receiver.
- Plug the iPad cord into the communication port indicated by the iPad Integration Control.

Please refer to the instruction manual for more detailed instructions and diagrams.