User Manual Q&AAnswer
Feb 04, 2025 - 06:16 AM
To connect your RS485 devices to the Milesight UC100 LoRaWAN IoT Controller, follow these steps:
1. Connect your RS485 device to the RS485 port on the UC100 device.
2. Open the Milesight ToolBox software on your computer.
3. Power on the UC100 device and connect it to your computer via the type-C port.
4. In the ToolBox software, select the "General" type and click on the password field to log in (default password: 123456).
5. Once logged in, go to the "General -> RS485" page to enable RS485 and configure the serial port settings. The serial port settings should match the settings of your RS485 terminal devices (stop bit, data bit, parity, baud rate).
6. Save the configurations and the UC100 device will be connected to your RS485 devices.
Please refer to the Milesight UC100 LoRaWAN IoT Controller User Guide for more detailed instructions and information on configuring the RS485 settings.
Add New Comment