User Manual Q&AAnswer
Feb 04, 2025 - 05:58 AM
To install the Good Earth AC1347-RGB-07LF0-G LED USB Tape Light, follow these steps:
1. Choose a location for the LED tape light and mark it. Make sure the USB cord can reach the nearest USB port.
2. Clean the mounting surface with rubbing alcohol and let it dry.
3. Do not plug the USB cord into the power source until installation is complete.
4. Carefully remove the backing liner from the LED tape light without peeling away the mounting glue.
5. Place the LED tape light in the desired position and apply pressure along its entire length to ensure proper adhesion.
6. Allow the tape adhesive to cure for 24 hours before use.
Note: Once the tape light is mounted, avoid repositioning it as it may reduce the adhesiveness of the tape backing.
To connect the USB cord, firmly plug the USB connector into a television, computer laptop, or USB adaptor.
For more detailed instructions and safety information, please refer to the Good Earth AC1347-RGB-07LF0-G LED USB Tape Light instruction manual.
Add New Comment