User Manual Q&AAnswer
Feb 04, 2025 - 05:24 AM
To assemble the FUDESY FDS2030B 7x10Ft Backdrop Stand, please follow these steps:
1. Start by unpacking all the components from the package, including the support stands, crossbar, and spring clamps.
2. Extend the support stands to their full height by pulling the sections apart. Make sure the locking mechanisms are securely in place to hold the stands at the desired height.
3. Place the support stands on a flat surface, ensuring they are stable and not tilting or toppling.
4. Take the crossbar and insert it into the top section of one support stand. Adjust the length of the crossbar by sliding it in or out until it reaches the desired width for your backdrop.
5. Repeat the same process with the other end of the crossbar, inserting it into the top section of the second support stand.
6. Once the crossbar is securely in place, tighten the locking mechanisms on each support stand to hold the crossbar firmly.
7. Attach the spring clamps to the crossbar at the desired height, ensuring they are evenly spaced and securely holding the backdrop.
8. Adjust the height of the support stands if needed to ensure the backdrop is at the desired level.
9. Before using the backdrop stand for shooting, it is recommended to assemble and break it down at least once to familiarize yourself with the process.
Please refer to the FUDESY 7x10Ft Backdrop Stand pdf manual for visual instructions and additional information on using and maintaining the backdrop stand.
Add New Comment