User Manual Q&AAnswer
Feb 04, 2025 - 03:54 AM
To install and set up the Clarion CMR-20 Wired Marine Remote Control With Display, please follow the instructions provided in the owner's manual. Here is a step-by-step guide:
1. Mounting the Remote Control:
- Choose a suitable location on your boat or vehicle to mount the remote control. Ensure it is easily accessible and within reach.
- Use the included mounting bracket and screws to secure the remote control in place.
2. Wiring Connections:
- Connect the remote control to the main Clarion marine audio unit using the provided wired connection.
- Refer to the wiring diagram in the owner's manual for the correct wire connections.
- Make sure to properly connect the power, ground, and audio signal wires.
3. Powering On and Pairing:
- Once the remote control is securely mounted and wired, turn on the main Clarion marine audio unit.
- The remote control should automatically pair with the audio unit.
- If it does not pair automatically, refer to the owner's manual for instructions on how to manually pair the remote control.
4. Display and Controls:
- The CMR-20 remote control features a display screen and various controls for audio playback and system settings.
- Use the display screen to view track information, radio station frequencies, and other relevant information.
- Use the control buttons to adjust volume, change tracks, switch audio sources, and navigate through menus.
5. Troubleshooting and Additional Features:
- If you encounter any issues during installation or operation, refer to the troubleshooting section in the owner's manual for possible solutions.
- The CMR-20 remote control may have additional features and settings that can be customized. Consult the owner's manual for detailed instructions on accessing and adjusting these settings.
Please note that this is a general guide, and it is important to refer to the specific instructions provided in the owner's manual for accurate and detailed installation and setup procedures.
Add New Comment