User Manual Q&AAnswer
Feb 04, 2025 - 03:16 AM
To install the Xblitz R5 Power Car Adapter in your car, please follow the steps below:
1. Remove the fuse in your car's fuse box and put it into the empty slot in the piggyback fuse cable ("original vehicle fuse" in the image).
2. Put the R5 Power piggy-back fuse cable into the now-empty slot in the fuse box.
3. Insert the stripping wire of the black cord into the GROUND terminal on the R5 Power body and lock the wire into place using the attached screwdriver. Make sure no copper wiring is sticking out of the terminal.
4. Insert the stripping wire of the red cord into the 12/24V positive terminal on the R5 Power body and lock the wire into place using the attached screwdriver. Make sure copper wiring is sticking out of the terminal. Double-check the wiring to avoid a short-circuit.
5. Attach the metal ring terminal from the black cord to a metal ground point on the body of the vehicle. Do not attach the ring terminal to a painted surface.
6. Insert the plug of the red cord into the receptacle of the piggyback fuse cable.
7. Press the power switch on the R5 Power, and check if the Control light is on.
8. Seal the paired cartridge connector in place with tape, close the vehicle fuse.
9. Fasten the parallel red and black cables to other vehicle cables using cable ties.
10. Your installation is complete. Enjoy your purchase!
Please refer to the Xblitz R5 Power Car Adapter user manual for more detailed instructions and illustrations.
Add New Comment