How do I program the remote for my FIRSTECH T13 2-Way RFX Bundle with LTE Module? (FIRSTECH T13 RFX Bundle LTE Module User Guide)

Answer

manuals.plus

Feb 04, 2025 - 03:15 AM


To program the remote for your FIRSTECH T13 2-Way RFX Bundle with LTE Module, follow these steps:



1. For a standard key start vehicle:

   - Activate programming mode by turning the vehicle's key between the ignition on and off (or the Acc & On positions) five times within 10 seconds. The parking lights will flash once to confirm.

   - Within 10 seconds, after the 5th ignition cycle, press and release the Lock button on the Firstech remote. The parking lights will flash once to confirm the remote has been coded. Repeat this step for each additional remote, up to 4.



2. For a PTS (Push to Start) vehicle:

   - Set the vehicle to the ignition or "ON" position.

   - Within 5 seconds, push to the "OFF" position.

   - Within 5 seconds, set the vehicle to the ignition or "ON" position (do not start).

   - Within 5 seconds, depress and release the foot brake 3 times. The parking lights will flash once to indicate remote programming is enabled.

   - Tap the Lock button on the remote. The parking lights will flash once to indicate the remote code has been accepted. Repeat this step for each additional remote, up to 4.

   - After 10 seconds of no valid remote codes being transmitted, the control module will automatically exit programming mode.



Note: If no valid remotes are programmed, the control module will enter valet mode.



Please refer to the user guide for additional information and programming options.