User Manual Q&AAnswer
Feb 04, 2025 - 02:58 AM
To set up the Invitrogen E-Gel Power Snap Plus Camera for the first time, follow these steps:
1. Remove the rubber connector plug from the camera.
2. Gently place the camera on the E-Gel Power Snap Plus Electrophoresis Device, aligning the camera and docking connectors.
3. Lower the camera into place.
4. The camera screen will briefly display a welcome screen and then change to the home screen when it is ready for use.
Note: The first-time setup should be done by an Administrator.
Add New Comment