User Manual Q&AAnswer
Feb 04, 2025 - 02:34 AM
To install the ULTRALUX Utility LED Vanity Light Bar, follow these steps:
1. Shut off the main electrical supply from the main fuse box/circuit breaker.
2. Remove the contents from the box and ensure that no parts are missing. Refer to the illustration in the installation instructions.
3. Locate the black and white supply wires and the supply ground wire, and pull them from the junction box.
4. Loosen the two fixture set screws located on the fixture back plate, then slide and pull the mounting bracket out from the fixture back plate.
5. Rotate the mounting bracket 90 degrees and align it with the holes on the outlet box. Tighten the two screws located in the center of the mounting bracket.
6. Attach the mounting bracket to the junction box using the mounting screws.
7. Make the following wire connections using the provided wire nuts:
- Connect the white (neutral/common) supply wire to the white fixture wire.
- Connect the black (line) supply wire to the black fixture wire.
- Connect the supply ground wire to the fixture ground wire.
If necessary, wrap all wire connections in electrical tape to ensure a secure connection.
8. Carefully tuck all wiring back into the junction box.
9. Slide the fixture back plate back onto the mounting bracket and secure it in place by tightening the two fixture set screws.
10. Restore power at the fuse box/circuit breaker and check the operation of the integrated LED fixture.
11. Installation is complete.
Please note that it is important to consult a qualified electrician if you are unfamiliar with proper electrical wiring connections. Also, ensure that you follow all safety precautions and turn off the power before installation, inspection, or removal. For more detailed instructions and illustrations, refer to the ULTRALUX Utility LED Vanity Light Bar User Manual.
Add New Comment