User Manual Q&AAnswer
Feb 04, 2025 - 01:41 AM
To install the CZC AUTO 8542079007 12V LED Trailer Tail Light Kit, follow these steps:
1. Start by disconnecting the trailer's battery to ensure safety during installation.
2. Locate the existing tail light wiring on your trailer. If there is no existing wiring, you may need to consult a professional or refer to your trailer's manual for guidance.
3. Connect the white ground wire from the tail light kit to the trailer's frame or grounding point. This will provide a secure ground connection for the lights.
4. Connect the remaining wires from the tail light kit to the corresponding wires on your trailer. The colors of the wires may vary depending on your trailer's wiring system, so refer to the wiring diagram provided in the CZC AUTO 8542079007 12V LED Trailer Tail Light Kit user guide.
5. Once all the wires are securely connected, use electrical tape or wire connectors to protect the connections from moisture and ensure a reliable connection.
6. Mount the tail lights onto the trailer using the provided mounting hardware. Make sure they are securely attached and positioned correctly for optimal visibility.
7. After installation, double-check all connections and ensure that the lights are functioning properly. Test the stop, turn, tail, rear reflector, side reflector, side marker, and license plate lights to ensure they are working as intended.
8. Finally, re-connect the trailer's battery and test the lights again to ensure they are functioning correctly.
If you encounter any issues during installation or have further questions, refer to the CZC AUTO 8542079007 12V LED Trailer Tail Light Kit user guide or contact CZC AUTO customer support for assistance.
Add New Comment