User Manual Q&AAnswer
Feb 04, 2025 - 12:58 AM
To connect the Powersoft T902 amplifier to your audio system, follow these steps:
1. Locate the input connections on the rear panel of the amplifier. The T902 amplifier has two-channel inputs, labeled "Analog input 1" and "Analog input 2." These inputs use XLR female connectors.
2. Connect your audio source to the amplifier using XLR cables. Plug one end of the XLR cable into the output of your audio source (such as a mixer or audio interface) and the other end into the corresponding input on the amplifier.
3. If you want to link multiple amplifiers together, there are also XLR male connectors labeled "Analog 1" and "Analog 2 link output." You can use these outputs to connect to the input of another amplifier.
4. For the output connections, the T902 amplifier has Speakon NL-4 connectors. The right channel output is labeled "channel 1+2" and "channel 2+n.c." Connect your speakers to these outputs using Speakon cables.
5. Make sure to properly ground the amplifier by connecting the electrical safety earth to the chassis via the dedicated Protective Earth wire. This is important for safety and to limit hum and interference.
Please refer to the user guide for more detailed instructions and illustrations on connecting the Powersoft T902 amplifier to your audio system.
Add New Comment