User Manual Q&AAnswer
Feb 03, 2025 - 11:01 PM
To connect the Ecler eHSA2-250 Multichannel Amplifier to your speakers, follow these steps:
1. Make sure the amplifier is turned off and the power cord is unplugged from the mains.
2. Locate the Euroblock connectors on the rear panel of the amplifier labeled "100V OUTPUTS."
3. Take the speaker cables and connect the positive (+) and negative (-) terminals of each speaker to the corresponding terminals on the Euroblock connectors. Ensure a secure connection.
4. Use good quality, shielded speaker cables with sufficient section and keep the cable length as short as possible, especially for long distances.
5. Once the speaker connections are made, you can plug in the power cord and turn on the amplifier.
Note: It is important to follow the installation guidelines provided in the manual to avoid any malfunctions or damage to the unit.
Add New Comment