How do I install the Paulmann 798.6 MaxLED 250 LED Strip? (Paulmann MaxLED LED Strip Instruction Manual)

Answer

manuals.plus

Feb 03, 2025 - 10:38 PM

Installation of the Paulmann 798.6 MaxLED 250 LED Strip is relatively straightforward. Here are the step-by-step instructions:

1. Unbox the product and ensure that all the components are present as listed in the "What's in the Box" section of the manual.

2. Before installation, make sure the power supply is disconnected to avoid any electrical hazards.

3. Decide on the desired location for the LED strip. It can be installed on various surfaces, such as walls, ceilings, or furniture.

4. Clean the installation surface thoroughly to ensure proper adhesion of the LED strip.

5. Peel off the adhesive backing from the LED strip and carefully stick it to the desired surface. Ensure that the strip is straight and aligned correctly.

6. Connect the LED strip to the power supply. Follow the instructions provided in the manual for proper wiring and connection.

7. Once the strip is securely installed and connected, you can turn on the power supply to test the lighting.

8. If necessary, you can cut the LED strip to the desired length using the designated cutting points. Please refer to the manual for specific instructions on cutting the strip.

9. If any issues arise during installation or operation, it is recommended to consult a qualified electrician for assistance.

Please note that the replaceability of the light source or operating device depends on the specific model. Refer to the "Replaceability" section in the manual to determine if the light source or operating device can be replaced by end users or a qualified electrician without permanently damaging the luminaire.

For further information or troubleshooting, you can refer to the complete instruction manual provided by Paulmann Licht GmbH, available on their website at www.paulmann.com.