User Manual Q&AAnswer
Feb 03, 2025 - 10:08 PM
To connect the Janitza Cloud Connector M, follow these steps:
1. Connect the device to the power supply.
2. Connect the device to the network via the Ethernet interface.
3. Optionally, connect further measuring devices to the device via the Modbus interface.
It is important to observe the voltage and frequency specifications on the rating plate and use commercially available patch cables for the intended interfaces. Improper connection can result in malfunction, damage to the device, or even risk of injury to persons. Make sure the Cloud Connector and the measurement devices are in the same network.
For more detailed instructions and safety precautions, please refer to the "Connection" section of the Janitza Cloud Connector M user manual.
Add New Comment