User Manual Q&AAnswer
Feb 03, 2025 - 09:33 PM
To connect the P34 Piezo Tip/Tilt Platform to the controller, please follow these steps:
1. Make sure the P34 piezo tip/tilt platform and the controller are both powered off.
2. Check the connection wire of the product to ensure it is in good condition.
3. Use the dedicated cable provided by CoreMorrow to connect the P34 Piezo Tip/Tilt Platform to the controller. Do not connect via an extension cable unless approved by CoreMorrow.
4. Connect the P34 connector (LEM0 connector) to the corresponding connector on the controller.
5. Ensure that the connection is secure and tight.
6. Power on the controller and follow the instructions in the controller's user manual for proper operation.
Please note that improper connection or disconnection of the wires during operation may cause damage to the product. It is important to follow the instructions and use the dedicated cable provided to ensure a proper and secure connection.
Add New Comment