User Manual Q&AAnswer
Feb 03, 2025 - 09:30 PM
To set up the Tamora II Digital dynamic mattress overlay system, follow these steps:
1. Setting up the mattress:
- Place the mattress overlay on top of the base mattress, ensuring that the air pipe connector is situated on the bottom left-hand side of the bed foot end.
- Secure the mattress overlay to the base mattress using the elastic security straps fitted to the base cover of the mattress overlay. Make sure the straps are only fitted to the moving parts of the mattress platform.
2. Setting up the power unit:
- Unfold the hanging hooks on the rear of the power unit and hang it from the bed's footboard. Alternatively, you can place the power unit on the floor at the foot of the bed.
- Ensure that the power cable is routed in a way that it cannot be twisted, trapped, crushed, or stressed.
3. Connecting the mattress to the power unit:
- Remove the cover of the air pipe connector and connect the air pipe connector to the power unit.
- Plug the power cable into a suitable electrical socket and switch it on using the mains power switch on the side of the power unit.
- Push the Operate button on the control panel to start the inflation process. The Auto-Firm indicator will flash.
- Once the mattress overlay is fully inflated, you can set the mattress to the appropriate setting suitable for the patient. Refer to Table 1 in the manual for the most suitable settings based on weight.
Note: Make sure to read the complete user manual for detailed instructions and safety information before using the Tamora II Digital dynamic mattress overlay system.
Add New Comment