User Manual Q&AAnswer
Feb 03, 2025 - 08:44 PM
To switch between different HDMI sources using the ecler VEO-SWH44 HDMI switcher, you can follow these steps:
1. Ensure that all the HDMI signal sources (such as a PC, Blu-ray player, etc.) are connected to the HDMI input ports of the VEO-SWH44 switcher.
2. Connect the HDMI output port of the VEO-SWH44 switcher to your display (e.g., TV or monitor).
3. Power up the VEO-SWH44 switcher, display, and all the connected sources.
4. On the front panel of the VEO-SWH44 switcher, you will find source selection LED indicators and a source selection mode button. Press and hold the source selection mode button for 2 seconds to enter the manual switching mode.
5. In the manual switching mode, you can press the source selection mode button normally to cycle through the input ports and select the desired HDMI source.
Alternatively, you can also control the VEO-SWH44 switcher using the included IR remote control. The remote functions are listed in the user manual.
Please refer to the "PANEL DESCRIPTION" section of the user manual for a visual representation of the front and rear panel of the VEO-SWH44 switcher.
Add New Comment