Answer

Feb 02, 2025 - 10:38 PM
To install the batteries in the ESKY Remote Key Finder, follow these steps:
1. Transmitter:
a. Remove the battery door located on the back of the transmitter.
b. Install 2 new AAA 1.5V batteries (not included) according to the (+) and (-) marks inside the battery compartment.
c. Push the battery door back into place.
2. Receiver:
a. Using a small coin, insert it into the slot on the battery cover and unscrew it in the arrowed direction.
b. Put one CR2032 button cell battery (included) into the battery compartment, making sure the "+" side of the battery is facing up.
c. Replace the battery cover and securely xxxx it into place.
Please note that it is important not to mix old and new batteries, and avoid mixing different types of batteries (e.g., Alkaline, standard, rechargeable). Also, remember to handle and dispose of old batteries properly to protect the environment and comply with the law.
Add New Comment