User Manual Q&AAnswer
Feb 02, 2025 - 04:34 AM
To install the Regalo 0723DS Easy Fit Plastic Adjustable Extra Wide Baby Gate, please follow the steps outlined in the owner's manual. Here is a step-by-step guide:
1. Before starting the installation, ensure that the gate fits the desired opening. The gate is adjustable and can fit openings from 29 to 50 inches wide.
2. Identify the hinge side and latch side of the gate. The gate should be installed with the hinge side on the side where you want the gate to swing open.
3. Position the gate in the desired opening, ensuring that it is level and centered.
4. Extend the gate until it fits tightly within the opening. The gate should be snug, but not so tight that it cannot swing freely.
5. Once the gate is in the correct position, locate the four wall cups included with the gate. These wall cups help secure the gate to the wall and prevent it from being pushed over.
6. Attach the wall cups to the wall using screws or adhesive (not included). Make sure the cups are securely fastened.
7. Slide the gate's hinge side into the wall cups, ensuring that it is properly seated and secure.
8. Check the gate's alignment and adjust if necessary. The gate should open and close smoothly without any obstructions.
9. Finally, test the gate's locking mechanism to ensure it is functioning correctly. The gate should securely lock in place when closed.
Please refer to the owner's manual for additional information, including safety precautions and maintenance instructions.
Add New Comment