User Manual Q&AAnswer
Feb 01, 2025 - 05:35 AM
To connect the COREMORROW E51.B3S Series Piezo Controller to a power supply, follow these steps:
1. Make sure the power supply is compatible with the controller's requirements. The controller requires a power supply of 20~30V.
2. Locate the +24V power supply terminal on the controller. It is labeled as "1" in the "Power supply and control" pin definition section of the manual.
3. Connect the positive terminal of the power supply to the +24V power supply terminal on the controller.
4. Connect the ground terminal of the power supply to the +24V power supply ground terminal on the controller. The ground terminal is also labeled as "1" in the "Power supply and control" pin definition section.
5. Ensure that the power supply is securely connected and the connections are tight.
Please refer to the "Power supply and control" section of the manual for more detailed information and pin definitions.
Note: It is important to read and understand the entire user manual before installing and operating the E51.B3S controller. If you have any further questions or concerns, please contact CoreMorrow customer service for technical support.
Add New Comment