User Manual Q&AAnswer
Feb 01, 2025 - 05:08 AM
To install the Haloview BTC128/BTC129 wireless rear view camera system, please follow these steps:
1. Remove the rear light from your vehicle using a straight screwdriver (refer to Figure 1, 2, and 3 in the manual).
2. Disconnect the cables from the rear light and pull them out (refer to Figure 4, 5, and 6).
3. Cut the cables using pliers and strip the cables to expose the conductive core (refer to Figure 7 and 8).
4. Secure the rear light camera base on the vehicle wall, aligning it with the pre-installed mounting holes (refer to Figure 9 and 10).
5. Ensure correct polarity when wiring the cables. Connect the red wire to the positive terminal and the black wire to the negative terminal (refer to Figure 11 and 12).
6. Make sure to seal and waterproof the wire connections and terminals (refer to Figure 13 and 14).
7. Clamp the terminals tightly to ensure they are sealed and waterproof (refer to Figure 15, 16, and 17).
8. Put the wires and terminals into the hole and fasten the rear light camera into the base (refer to Figure 18, 19, and 20).
9. Remove the cover of the rear light camera and secure the base with the provided screws. Finally, put back the cover (refer to Figure 21 and 22).
Please note that these instructions are a general guide. It is recommended to consult the user manual for specific details and illustrations related to your specific model (BTC128 or BTC129).
Add New Comment