User Manual Q&AAnswer
Feb 01, 2025 - 04:46 AM
To connect the WHADDA WPSE303 Soil Moisture Sensor and Water Level Sensor Module to an Arduino board, you will need an Arduino microcontroller (such as the Velleman WPB100 Arduino Uno) and the sensor module. Here are the steps to connect them:
1. Connect the +5V supply line (VCC) of the module to the 5V line of the Arduino board.
2. Connect the GND (common) connection of the module to the GND (0V) of the Arduino board.
3. Connect the analog signal output (usually marked as S on the module) to the analog input A0 of the Arduino board.
By following these steps, you will be able to read the sensor data from the module using the Arduino board.
Please note that the provided example code in the manual can be used for both the soil moisture sensor and the water level sensor. It demonstrates how to read the sensor value and control LEDs based on the moisture level. You can modify the code according to your specific requirements.
For more detailed information and additional guidelines, please refer to the WHADDA WPSE303 Soil Moisture Sensor and Water Level Sensor Module User Manual.
Add New Comment