User Manual Q&AAnswer
Feb 01, 2025 - 04:37 AM
To install the diamond slitting discs on the HILTI DCH 150-SL Wall Chaser, follow these steps:
1. Lay the tool on its left side with the spirit level facing up.
2. Press and hold down the carriage release button to unlock the carriage.
3. Swing the carriage out and let go of the carriage release button.
4. Fit the clamping flange onto the spindle.
5. Place the first diamond slitting disc on the clamping flange, making sure that the direction-of-rotation arrow on the slitting disc points in the same direction as the direction-of-rotation arrow on the power tool. Make sure to select the correct diamond slitting disc for the material you will be cutting.
6. Select the correct spacer rings for the desired slit width and place them on the clamping flange. The width of the slit is equal to the thickness of the two diamond slitting discs and the spacer rings inserted between them. The widths of the spacer rings are 4 mm, 7 mm, 13 mm, and 22.5 mm.
7. Place the second diamond slitting disc in position.
8. Place all the remaining spacer rings on the clamping flange.
9. Press and hold down the spindle lock button.
10. xxxx on the clamping nut and tighten it securely with the pin wrench. Release the spindle lock button and remove the pin wrench.
11. Pivot the carriage towards the body of the machine until it engages in position.
Make sure to follow these instructions carefully to ensure proper installation of the diamond slitting discs on your HILTI DCH 150-SL Wall Chaser.
Add New Comment