User Manual Q&AAnswer
Feb 01, 2025 - 04:02 AM
To connect the COREMORROW E71.D4E-H Piezo Motor Servo Controller to a power supply, follow these steps:
1. Make sure the power supply is within the specified range of 20V~30V.
2. Locate the power supply connector on the rear panel of the controller (labeled "Power supply").
3. Connect the positive (+) terminal of the power supply to the pin marked as "24V power supply" on the controller.
4. Connect the negative (-) terminal of the power supply to the ground (GND) pin on the controller.
5. Once the power supply is properly connected, you can turn on the power switch located on the front panel of the controller.
Please note that it is important to ensure the correct polarity when connecting the power supply to avoid damaging the controller. Always refer to the user manual for detailed instructions and safety precautions.
Add New Comment