User Manual Q&AAnswer
Feb 01, 2025 - 03:59 AM
To install the HOFTRONIC 5435911 Auto Detect Dimmer, please follow these steps:
1. Disconnect the power and lock out the relevant circuit at the mains switchboard.
2. Remove the existing switch from the wall.
3. Connect the dimmer according to the provided wiring diagrams.
4. Use 1.0 to 1.5mm rigid wire for the copper conductors of the terminals.
5. Refit the switch plate to the wall and attach the dimmer xxxx to the shaft.
6. Reconnect the power and use the xxxx to turn the dimmer on and off or adjust the brightness.
Note: When using multi-way operation, a retractive switch or push switch can control up to 20 units for dimming and switching. Do not connect two or more dimmers in parallel or series to control the same load from different locations.
For more detailed instructions and safety precautions, please refer to the HOFTRONIC 5435911 Auto Detect Dimmer User Manual.
Add New Comment