User Manual Q&AAnswer
Feb 01, 2025 - 03:35 AM
To install the Haloview BTC130 HD Wireless RV Rear Marker camera, please follow the steps outlined in the user manual:
1. Remove the rear light from the vehicle using a straight screwdriver (refer to Figure 1, 2, and 3 in the manual).
2. Disconnect the cables connected to the rear light and pull them out (refer to Figure 4, 5, and 6).
3. Cut the cables using pliers and strip the cables to expose the conductive core (refer to Figure 7 and 8).
4. Secure the rear light camera base on the vehicle wall, aligning it with the pre-installed mounting holes (refer to Figure 9 and 10).
5. Ensure correct polarity when wiring the cables, with red being positive and black being negative (refer to Figure 11 and 12).
6. Make sure to seal and waterproof the wire connections and terminals (refer to Figure 13, 14, 15, 16, and 17).
7. Put the wires and terminals into the hole and fasten the rear light camera into the base (refer to Figure 18, 19, 20, 21, and 22).
8. Remove the cover of the rear light camera and secure the base with the provided screws. Finally, put back the cover.
Please note that these instructions are a summary of the installation process. For more detailed instructions and illustrations, refer to the user manual provided with the Haloview BTC130 HD Wireless RV Rear Marker camera.
Add New Comment