User Manual Q&AAnswer
Feb 01, 2025 - 03:30 AM
To connect the Rayrun NT30 Smart and Remote Control RGB LED Controller to your LED fixtures, follow these steps:
1. Power supply input: Install the positive power cable into the terminal marked with ‘+’ and the negative power cable into the terminal marked with ‘-’. The controller accepts DC power from 12V to 24V. Make sure the LED rated voltage is the same as the power supply.
2. LED output: Connect your LED fixtures to the controller's LED output terminal. Install the LED common anode cable into the terminal marked with ‘+’, and connect each channel LED cable (R, G, B) into their respective terminals. Again, ensure that the LED rated voltage matches the power supply, and that each channel's maximum load current is below the controller's rated current.
Note: The controller has overload and short circuit protection. If the output is overloaded or short circuited, the indicator will flash red and the controller will stop working. Check the wiring and load current to resolve the issue.
For more detailed information and diagrams, please refer to the Rayrun NT30 Smart and Remote Control RGB LED Controller User Manual.
Add New Comment